WEINIG

OptiCut 200

Available for difficult and lower grade wood

If a push-feed saw no longer meets the customer’s capacity requirements in single-board operation and it is not possible to operate in pack cutting mode because defects must be cut out or random lengths have to be processed, the OptiCut 200 offers an entry-level option into a new class of optimizing cross-cut saws. It has the primary features of WEINIG DIMTER through-feed saws such as superior precision, advanced technical availability and, last but not least, low operating costs. Reliably high daily capacity, full optimization as standard and completely trouble-free operation are essential features of the OptiCut 200. The length measurement of the entire work piece is carried out independently of the drive and slippage before the first saw cut. This means maximum waste reduction and optimal value creation. This means that the DimterLine OptiCut quickly pays for itself.

The WEINIG OptiCut 200 provides

  • 5 driven feed rollers from below, pressure rollers from above
  • Pneumatic saw stroke
  • Cutting of cross-sections up to 260 x 12 mm or 160 x 80 mm is possible
  • Waste disposal via blow-out device
  • Saw blade diameter 500 mm
  • Measuring wheel in front of saw blade
  • Min. fixed length behind saw blade: 140 mm
  • Cutting tolerance ± 0.8 mm to 1000 mm length
  • Automatic sorting as standard
  Standard Optional
Saw motor performance 7.5 kW  
Saw blade Ø 500 mm 520 mm
Saw blade bore 30 mm  
Min. cut height 12 mm 3 mm
Max. cut height 80 mm 100 mm
Min. cut width 30 mm  
Max. cut width 260 mm  
Min. incoming length 400 mm   
Max. incoming length 6300 mm  
Min. nominal cross-section 30 x 12 mm  
Catalog EN